On the process flow of coating luggage fabric- Pesin Outdoor Products Company

The coating process of the bag fabric is a bag process that innovates the fabric and gives it a multi-faceted. It can also form a uniform layer of covering rubber on the surface of the fabric, thus achieving waterproof, windproof, breathable and other functions, commonly used coating foot forces include Pu glue, A/C glue, PE glue, DuPont protective coating, etc. Each glue will create luggage fabrics with different handfeel. Then this time talk about the process of coating the fabric of the bag. First: with the barrel, according to the requirements of the fabric coating, the cloth will be separated according to the cylinder number written by the dyeing factory. The Masters will clean the silk car and keep the silk car clean, prevent dust and stains from being adsorbed on the cloth. After that, put a piece of fabric in the silk car, and so on, until the silk car is paved. Second: sewing head, push the paved silk cart to the edge of the sewing machine, and lay a clean cloth on the ground between the silk cart and the sewing machine to keep the sewn head clean, the head of the cloth is connected with a sewing machine. At this time, the Masters will connect the heads of every two pieces of cloth to form a whole piece of cloth, connect the other two adjacent heads, and push the silk cart with the heads sewn to the front of the coating machine, in order to accurately and Neatly sew fabrics. Third: on the machine coating, before the coating, we and the master should clean the coating machine and the machine room, and sprinkle water in the workshop, and place the return electrostatic adsorption to affect the purity of the coating. After preparation, first adjust the silk cart, then wear the lead cloth on the coating machine, connect the tail of the lead cloth with the head on the silk cart with a sewing machine, and start the machine, open the joint to the position of the coated knife. Adjust the position of the slurry board. During the preparation of the coating, according to the requirements of the coating, the sizing master will prepare the slurry according to the requirements of the process sheet formula, and stir the prepared slurry with a beater, and stir evenly for later use, set the temperature control switch to the specified temperature and raise the temperature. After the temperature rises to the specified temperature, turn on the exhaust. Pour the prepared slurry onto the bottom plate of the coated knife, start the machine and start coating. Fourth: inspection, after the first three processes, the Masters have completed the basic work of fabric coating. Now, it is necessary to put the coated cloth behind the cloth inspection machine and lay a clean cloth on the ground to keep it clean. After that, the Masters will wear the large roll of cloth on the cloth inspection machine, turn on the light of the cloth inspection machine, and Mark, record and rectify the defects on the cloth as required. The coating process of luggage fabric is demonstrated by the board master of Pesin Outdoor Products Company, which truly shows the process of luggage customization to customers.